YES! Some of my favorite stuff (next to PDMS) is the "Press-n-Peel" PCB
film (http://www.techniks.com/). It's a film that you can run through a
laser printer. The ink stays on the film, but is easily transferred
when you iron it onto your substrate, It is not high resolution (maybe
100 um), but is easy and cheap and stands up to standard copper etchant.
M
Chong Xie wrote:
> Go a bit further from this point. You could transfer laser printed
> pattern to your surface by transparency films easily. The ink works
> fine as mask. This may give you a little better resolution and make
> your design easier.
>
> Chong
>
> Clifford Hicks wrote:
>>
>> Probably not what you are looking for, but a Sharpie pen works well,
>> the kind that writes on metal or other smooth surfaces. If it's a big,
>> simple design you can draw it by hand and the pen ink itself is a pretty
>> good resist.
>>
>> - Clifford
>>
>>
>>> Hello,
>>> I'm hoping to etch patterns into/through copper, nickel, and/or
>>> aluminum
>>> foils using an aqueous solution of FeCl3. I was wondering if anybody
>>> has
>>> any experience etching any metals with FeCl3, and which masks work for
>>> this
>>> process. Any help would be greatly appreciated! Thanks,
>>> Kevin
>>> kcrabb@stanford.edu
>>>
>>>
>>
>>
>>
>>
>
--
Mary X. Tang, Ph.D.
Stanford Nanofabrication Facility
CIS Room 136, Mail Code 4070
Stanford, CA 94305
(650)723-9980
mtang@stanford.edu
http://snf.stanford.edu
No comments:
Post a Comment